



- Công bố khoa học và công nghệ Việt Nam
Kỹ thuật quá trình hóa học nói chung
Tổng hợp và thử hoạt tính sinh học của khuôn định dạng hydroxyapatit trên nền chitosan
Synthesis and Evaluation of the Biological Activity of Hydroxyapatite/Chitosan-based Scaffold
Khoa học và Công nghệ các trường Đại học Kỹ thuật
2020
140
56-60
2354-1083
Trong nghiên cứu này, khuôn định dạng ứng dụng trong kỹ thuật mô xương được chế tạo từ vật liệu vô cơ hydroxyapatit trên nền chitosan. Sự kết hợp giữa hydroxyapatit và chitosan sẽ làm tăng khả năng tương thích sinh học của khuôn định dạng. Khuôn định dạng tổng hợp bằng phương pháp đổ dung môi rửa hạt. Hoạt tính sinh học được đánh giá thông qua các thí nghiệm in vitro trong dung dịch giả plasma (SBF). Kết quả nghiên cứu cho thấy khuôn định dạng HAp/chitosan có cấu trúc lỗ xốp và liên thông, với kích thước lỗ trung bình khoảng 200 μm và độ xốp khoảng 79 %, tạo ra lớp khoáng apatit sau 10 ngày ngâm trong dung dịch SBF. Tuy nhiên, khuôn định dạng chitosan sau 10 ngày ngâm không tạo ra lớp khoáng apatit. Kết quả cho thấy, khuôn định dạng HAp/chitosan có khả năng tương thích sinh học tốt hơn khuôn định dạng chitosan.
In this study, porous scaffolds were fabricated using inorganic material-hydroxyapatite and chitosan for bone-tissue engineering. The combination of hydroxyapatite and chitosan may result in increasing biocompatibility of the scaffolds. The scaffolds were prepared by solvent casting and paticulate leaching method. Bioactivity of the scaffolds was evaluated through in vitro experiments by soaking scaffold samples in simulated body fluid (SBF). The scaffolds obtained were highly porous and interconnected with a mean pore size of around 200 μm and porosity about 79 %. The apatite-mineral layer was produced on the HAp/chitosan after 10 days of soaking in SBF, however, it was not observed on the chitosan scaffold after 10 days soaking. The results revealed that the HAp/chitosan scaffold showed better bioactivity than the chitosan scaffold.
TTKHCNQG, CTv 140
- [1] Hoai, T.T. and N.K. Nga (2018), Effect of pore architecture on osteoblast adhesion and proliferation on hydroxyapatite/poly (D, L) lactic acid-based bone scaffolds.,Journal of the Iranian Chemical Society 15 (2018) 1663-1671.
- [2] Koutsopoulos, S (2002), Synthesis and c-haracterization of hydroxyapatite crystals,Journal of Biomedical Materials Research. 62(4)(2002) 600-612.
- [3] Kokubo, T. and H. Takadama (2006), How useful is SBF in predicting in vivo bone bioactivity?,Biomaterials, (2006) 2907-2915.
- [4] Kothapalli, C.R.; M.T. Shaw; and M. Wei (2005), Biodegradable HA-PLA 3-D porous scaffolds: effect of nano-sized filler content on scaffold properties.,Acta biomaterialia. 1(6) (2005) 653-662.
- [5] Nga, N.K.; et al (2014), Surfactant-assisted size control of hydroxyapatite nanorods for bone tissue engineering.,Colloids and Surfaces B: Biointerfaces. 116 (2014) 666-673.
- [6] Nga, N.K.; T.T. Hoai; and P.H. Viet (2015), Biomimetic scaffolds based on hydroxyapatite nanorod/poly (D, L) lactic acid with their corresponding apatiteforming capability and biocompatibility for bonetissue engineering.,Colloids and Surfaces B: Biointerfaces .128 (2015) 506-514.
- [7] Vương, B.X (2018), Tổng hợp và đặc trưng vật liệu composite hydroxyapatite/chitosan ứng dụng trong kỹ thuật y sinh.,Tạp chí Khoa học ĐHQGHN: Khoa học Tự nhiên và Công nghệ. Tập 34(Số 1) (2018) 9-15.
- [8] Yu, C.-C.; et al (2013), Electrospun scaffolds composing of alginate, chitosan, collagen and hydroxyapatite for applying in bone tissue engineering,Materials Letters. 93 (2013) 133-136.
- [9] Venkatesan, J.; et al. (2011), Preparation and c-haracterization of carbon nanotube-grafted-chitosan–natural hydroxyapatite composite for bone tissue engineering,Carbohydrate Polymers .83(2) (2011) 569-577.
- [10] Mikos, A.G. and J.S. Temenoff (), Formation of highly porous biodegradable scaffolds for tissue engineering.,Electronic Journal of Biotechnology. 3(2)2000 23-24
- [11] Mano, J. and R. Reis (2007), Osteochondral defects: present situation and tissue engineering approaches.,Journal of tissue engineering and regenerative medicine. 1 (2007) 261-273.
- [12] Karp, J.M.; M.S. Shoichet; and J.E. Davies (2003), Bone formation on two‐dimensional poly (DL‐lactide‐co‐ glycolide)(PLGA) films and three‐dimensional PLGA tissue engineering scaffolds in vitro.,Journal of Biomedical Materials Research Part A: An Official Journal of The Society for Biomaterials, The Japanese Society for Biomaterials, and The Australian Society for Biomaterials and the Korean Society for Biomaterials. 64 (2003) 388-396.
- [13] Kumar, M.R.; et al (2004), Chitosan chemistry and pharmaceutical perspectives,Chemical reviews. 104 (2004) 6017-6084
- [14] Rinaudo, M (2006), Chitin and chitosan: properties and applications.,Progress in polymer science. 31(2006) 603-632.
- [15] T.T. Hoai; N.K Nga; L.T. Giang; T.Q. Huy; P.N.M. Tuan (2017), B.T.T. Binh Hydrothermal Synthesis of Hydroxyapatite Nanorods for Rapid Formation of Bone-Like Mineralization.,Journal of Electronic Materials. 46(8) (2017) 5064-5072.